—#160148

Product

ECG Out Cable - Heartstart MRx M1783A/M5526A 12-pin Sync cables All units of Philips sync cables model M1783A and M5526A as well as Philips ECG out cables model 989803195641. Manufactured - September 4, 2002 October 8, 2014

FDA product code: MKJ — Automated External Defibrillators (Non-Wearable)
Device class: Class 3
Medical specialty: Cardiovascular
510(k) numbers: K031187, K040404, K051134, K061707, K062233
Affected lot / code info: M1783A/M5526A 12-pin Sync cables All units of Philips sync cables model M1783A and M5526A as well as Philips ECG out cables model 989803195641

Why it was recalled

Issue with ECG out cables. When a Philips monitor/defibrillator is receiving an ECG signal from an auxiliary bedside monitor via a sync cable or ECG out cable, the following can occur if the monitor/defibrillator experiences interference from electrical fast transients (EFTs): " On the HeartStart MRx and HeartStart XL, EFT noise may be misinterpreted as an R-wave. " On the HeartStart XL+, EFT noise can disable ECG monitoring and potentially interrupt demand mode pacing*. *Note: It is contrary to the XL+ Instructions for Use to perform demand mode pacing while using the ECG out cable or obtaining the ECG signal from a bedside monitor. The XL+ Instructions for Use includes the following warning: When pacing in Demand Mode, the ECG cable from the patient must be directly connected to the HeartStart XL+. If the user follows this warning, this problem cannot occur on the XL+.

Root cause (FDA determination)

Device Design

Action the firm took

Philips is asking customers to follow the Action to be Taken by Customer/User section of the Urgent Medical Device Correction notification/Field Safety Notice: Customers should remove affected sync cables and ECG out cables from service and destroy them, documenting such action on the attached reply form, which should be returned to Philips. Customers should retain a copy of the reply form. The customer should follow the Instructions for Use that describe the recommended approach for performing cardioversion with the XL+ and MRx monitor/defibrillators. The ECG trunk cable can be disconnected from the Philips bedside monitor and connected to the monitor/defibrillator before delivering therapy; this is the preferred source of an ECG waveform for synchronization.

Recalling firm

Firm: Philips Electronics North America Corporation
Address: 3000 Minuteman Rd, Andover, Massachusetts 01810-1032

Distribution

Distribution pattern: 1067 US customers 163 Canada, 917 International

Timeline

Recall initiated: 2017-07-17
Terminated: 2018-07-12
Status: —

Source: openFDA Device Recall endpoint. Recall record ID #160148. The FDA issues recall classifications as health-hazard assessments, not legal findings; for legal claims consult a licensed attorney.